Page 27 - WTS Catalog 2025

Two AC inputs with integrated transfer switch The Quattro can be connected to two independent AC sources, for

example the public grid and a generator, or two generators. The Quattro will automatically connect to the active

source.

Two AC Outputs

The main output has no-break functionality. The Quattro takes over the supply to the connected loads in the event of a

grid failure or when shore/generator power is disconnected. This happens so fast (less than 20 milliseconds) that

computers and other electronic equipment will continue to operate without disruption.

The second output is live only when AC is available on one of the inputs of the Quattro. Loads that should not discharge

the battery, like a water heater for example, can be connected to this output.

Split phase and three phase capability

Two units can be configured for split phase, and three units can be configured for three phase output. But that’s not all:

up to 4 sets of three units can be parallel connected to provide 96W / 120kVA inverter power and more than 1600A

charging capacity. For more detail please enter parallel in the search box on our website.

PowerControl – Dealing with limited generator, shore side or grid power

Quattro A current limit can be set on each AC input. The Quattro will then take account of other AC loads and use whatever is

48/5000/70-100/100 spare for charging, thus preventing the generator or mains supply from being overloaded. PowerAssist – Boosting shore

or generator power

This feature takes the principle of PowerControl to a further dimension allowing the Quattro to supplement the capacity

of the alternative source. Where peak power is so often required only for a limited period, the Quattro will make sure that

insufficient mains or generator power is immediately compensated for by power from the battery. When the load reduces,

the spare power is used to recharge the battery. Solar energy: AC power available even during a grid failure

The Quattro can be used in off grid as well as grid connected PV and other alternative energy systems.

Loss of mains detection software is available. System configuring

- In case of a stand-alone application, if settings have to be changed, this can be done in a matter of minutes with

a DIP switch setting procedure.

Ekrano GX or Cerbo GX - Parallel and three phase applications can be configured with VE.Bus Quick Configure and VE.Bus System

Provides intuitive system control and Configurator software.

monitoring and enables access to our - Off grid, grid interactive and self-consumption applications, involving grid-tie inverters and/or MPPT Solar

free remote monitoring website: the Chargers can be configured with Assistants (dedicated software for specific applications).

VRM Online Portal.

On-site Monitoring and control

Several options are available: Battery Monitor, Multi Control Panel, Color Control GX or other GX devices, smartphone or

tablet (Bluetooth Smart), laptop or computer (USB or RS232).

Remote Monitoring and control

Color Control GX or other GX devices.

Data can be stored and displayed on our VRM (Victron Remote Management) website, free of charge.

Remote configuring

When connected to the Ethernet, systems with a Color Control GX or other GX device can be accessed, and settings can

be changed remotely.

VRM Portal

Our free remote monitoring website

(VRM) will display all your system data in a

comprehensive graphical format. System

settings can be changed remotely via the

portal. Alarms can be received by e-mail

or push notification.

VRM app

Monitor and manage your Victron

Energy system from your smart

phone and tablet. Available for both

iOS and Android.